Mathews Grips 5 Angles for Triax Halon Monster Switchback TRX (2018 & Older)

*** IMPORTANT - Custom Ordering ***Ebay has a hard cap for the amount of variations I can have active. So some combinations are not shown and need to be requested. For the following situations below, I have additional steps to order:LEFT HAND OPTION - Left hand grips need to be requestedOPTION NOT LISTED - Certain combinations of grip angle, texture and

color are not active and need to be requested~~~ Steps to Order for options not listed ~~~During checkout, there is a section "Add note for seller". You can request any options above such as left hand or grip angle /

color option not active.After ordering, please message me with the same note during checkout. This is to ensure I get the order correct if ebay doesn't pass me the information.--- Bow Model Fitment --- This listing will only fit Mathews bows that are 2018 and older (some exceptions listed at the end). If you bow had a removable wooden grip, focus grips or the flatback grips then these are made to fit. Some models it will fit are:Chill (R, X, SDX) ModelsCreed (XS) ModelsDrenalin (LD) ModelsHalon (32 Series, 5, 6, 7, X) ModelsMonster (XLR8, MR5, MR6, MR8) ModelsNo Cam (HTR, HTX) ModelsSwitchback (LD, XT, S2) ModelsTRX (7, 8, 38) ModelsZ (Z2, Z3, Z7, Z9, ZXT) ModelsAvailHeli-MJewelLegacyTriax* Exception: Some models released after 2018 will still fit these bows as their original launch date was 2018 and older. For example the Avail was made in 2020 but use these older style grips as the original launch was in 2017 and they kept the same grip. This will also apply to the TRX 7, TRX 8, TRX 38, and Triax. * Non-Compatible: Some models are NOT able to fit these grips as Mathews instead integrated the grip into the riser. The following bows fall under this category:Chill X ProConquest 4, Apex 7, Apex 8Monster Safari & WakeTRG 7, TRG 8, TRG 9Prestige--- What's Included --- 1) Grip - 1 grip in your choice of

color and grip angle Decided to make grips for the older Mathews models. I wanted to bring over angle options to help those who wanted to get a more natural wrist position which would translate to a steadier hold.--- Color Options --- Colors available are shown in the 2nd picture showing the

color options. If you wanted a combination that is not active just message me.--- Installation --- The grip will come pre-installed with the duct tape on the inner side. I have a picture showing how it is installed. You may also use electrical tape if needed. I put it on the inner side of the grip so the tape doesn't get stuck to the riser's finish. This gives it a extra friction for fitment.The grip is made to friction fit over the riser. Before installing remove all leftover sticky residue on the riser. You may opt to leave the sticky residue on the FACE of the grip. But remove any on the sides of riser.