Dana / Integral Axle Housing Case Spreader - Dana 30 thru Dana 80

Our PEM Rear Housing Case Spreader is designed for use in Dana and Integral Housing applications only. step 1. To begin, adjust the spreader to fit the dowel holes of the particular Dana Spicer® housing you are working on. This is done by either manipulating the threaded adjuster, or for larger rear ends (D70 & D80), by changing the overall spread of the tool. The upper and lower bars have two sets of holes drilled in them allowing for adjustment to adapt to a variety of applications. step 2. After the spreader is set into place, snug the adjuster just enough to allow the spreader to hold itself in place. Once you have the spreader set up, you will need to use a dial indicator with a magnetic base across the opening of the housing. step 3. Once you have everything set up, you are ready to spread the housing. You need to pay close attention to the dial indicator reading as it is possible to over-spread the housing. You should never spread the housing more than ”. More than this can cause severe damage. In most cases you will still need to pry the carrier out of the housing – even with the spreader in place.When re-installing the carrier with the housing spread, you should still have to tap the carrier into place; the carrier should not drop freely Can be used on Dana 30-80 HousingsCan be used for GM10 and 12 Bolt Housings by making custom pins from a 7/8 Fine Thread BoltThis spreader is not compatible with Corvette HousingsNote: Will not work with Dana 35 with dowel pins under the cover. Disclaimer. Warning! Auto racing is a hazardous sport. No warranty or guarantee is made or implied regarding any racing product sold by Performance Engineering and Manufacturing, LLC. User assumes all risks. We will ship using USPS Priority Mail with Insurance and will send a Tracking/Delivery Confirmation Number after shipped. WARNING: Cancer And Reproductive Harm- www.P65Warnings.ca.gov