Aluminized Metallic Heat Shield Sleeve Wire Hose Cover Loom 1/2in 2.5ft
This aluminized metallic heat shield sleeve is designed to help protect wire, hose, or loom sections from radiant heat exposure in automotive applications. The item is listed as New and includes a 1/2 inch size and 2.5 ft length as shown in the title. It can be used as a protective cover for wiring or small hoses where added insulation is needed. Free Shipping is included with this listing. Check the listing for details on fitment, installation guidance, and any included accessories or packaging.
| Location | Aurora, Illinois US |
| Shipping | Free shipping (check listing for details) |
| Seller |
3xjacks
99.5% positive · 105154 feedback
|
| Listing | FixedPrice · Active |
| Restocking Fee | No |
| Return shipping will be paid by | Buyer |
| Returns Accepted | Returns Accepted |
| Item must be returned within | 30 Days |
| Refund will be given as | Money Back |
| Manufacturer Part Number | ALHS-AA10 |
| Brand | JC Performance USA |
1/2" I.D. x 2.5 feet (Approx. 13mm I.D.) Cool down with JC Performance Cool Sleeves©. Available in multiple lengths and diameters to fit: wiring, fuel lines, brake lines, intake tubes, intercooler pipes, spark plug wires, battery cables, A/C hoses, radiator hoses and more. · 1st Quality Fiberglass, Silicone Bonded to an Aluminum Alloy outer skin · Designed to provide maximum heat reflectivity while also protecting from chemical, oil leaks & spills, dirt, road grime and other underhood hazards · Pliable enough to be shaped to fit the tightest bends. · Better than heavy silicone tape, sleeves are lightweight, easy to install and easy to remove · Reflects over 90 % of Radiant Heat · Rated for Extreme Heat: § Continuous exposure to 1100 degrees § Intermittent exposure to 2000 degrees § Direct contact to surfaces up to 500 degrees · Fireproof · Oil Resistant · Light Weight Easy to trim. Slides right over wires, cables and hoses. For best results seal the sleeves at each end with adhesive foil tape, shrink tube or stainless steel cable ties. Sleeves are conductive always insulate electric terminals that it might come in contact with sleeves. To ensure a proper fit, allow extra room for bends (for example: a 90º bend in a 3/4" tube will NOT fit in 3/4" I.D. Sleeve, In this case you would need 1" I.D. or higher) I.D. = Inside Diameter CHECK OUT OUR FIBERGLASS, LAVA AND CERAMIC WRAP COMBINATIONS, KITS, ROLLS, TURBO BLANKETS, PROTECTIVE SLEEVES & MORE. STAINLESS TIES IN 3/16" (STANDARD) AND 5/16 (MONSTER) IN LENGTHS FROM 4"- 54"! AND PACKS FROM 5-100
